May 09, 2009
by: jovial_cynic

I needed new tires for my 510, as the tires that came with the car were nearing bald when I got it. The gold 13" Enkei mesh wheels that I've got on the car felt a little small as they were, so I figured I'd also look for some 14" wheels to throw under the car.

Doing a little research, it turns out that new tires run a little over $200 for a set, so these blue 14" Enkei mesh wheels I found turned out to be a great deal: $100 for the wheels AND the tires, which are practically in new condition.

The new wheels have a few curb rashes and a small dent in one place, but for $100, I can't complain. I had to get new tires anyway; these wheels were cheaper than free, as far as I'm concerned.

Here are the old wheels for comparison:

I still need to raise up the rear end of the car; it's much lower than I want it to be.
np category: 510


Joe said:
Hi, got a question concerning using KA24 (240SX) pistons and rods in a NAPZ 2.4 engine. Any thoughts on if this is possible and is there a better way to boost a NAPZ 2.4? Thanks for your time! Joe
July 22, 2009

jovial_cynic said:
Hey Joe -

Everything I know about mixing and matching Datsun engine parts can be found here. Hope that helps.

July 23, 2009

add comments. you are limited to 5,000 characters:

<< your name
<< your email (won't be displayed)
<< your website / location
<< type these numbers: 494881 (plus 0NE)

(html -enabled- / no scripts)

<< Comments temporarily disabled >>

Rules: Don't spam. Don't harrass. Don't be a jerk. Your IP address ( will be logged.